User Manual

SET
Variable Description
PAN ENABLE bitmap This command controls incoming PAN connections.
Bitmap:
1: Allow incoming PAN-PANU connections.
2: Allow incoming PAN-GN connections.
4: Allow incoming PAN-NAP connections.
8: Enable zeroconf for incoming PAN-PANU connec-
tions.
16: Enable zeroconf for outgoing PAN-PANU connec-
tions.
The default value "6" is recommended for most cases.
CONTROL AUTOEXEC cmd Run the CALL command, and rerun it when the call is
disconnected. Example: SET CONTROL AUTOEXEC
CALL bdaddr PAN-NAP PAN-NAP
CONTROL PASSWORD Do not require a password from iWRAP clients.
CONTROL PASSWORD pass
{--LOCAL}
Enable password. iWRAP clients must send this
password before giving any other command. The
password is case sensitive.
With an optional --LOCAL parameter, clients connect-
ing from localhost are accepted without a password.
CONTROL PING seconds
If this setting is enabled (seconds > 0), the iWRAP
server sends a PING reply to all iWRAP clients. You
have to reply to it with PONG or the connection will
be closed.
CONTROL WRITETIMEOUT
timeticks
With this command, you can set in timeticks (1/20s)
how long iWRAP tries to write to the datasocket if it’s
blocked before giving up and closing the connections.
CONTROL AUTOSAVE what
filename
If this setting is enabled, the system automatically
saves settings to a file when they change. See the SAVE
command for possible "what" values.
link_id MSC value Set MSC for link_id to value. See ETSI TS 101 369
(GSM 07.10) for more information.
link_id ACTIVE With this command, you can set the powermode for a
link_id to active.
79