User Manual

Appendix B. Setup Options
the file, this timeout (in seconds) defines when ObexSender can
send content to the same device again.
6. Delay between retrying call [120]
When user doesn’t accept or reject the file, ObexSender will try to
send the file again. This setting determines the timeout (in seconds)
before resend occurs. Default value is 120 seconds.
If you wish to disable this feature you can use the same value as in
"ok delay" or "reject delay", i.e. the two previous settings.
7. Delay after scanning [5]
When a remote request from user has been received, this setting
determines how long (in seconds) ObexSender will wait until the
response file is sent back to the user.
Default value is 5 seconds, because some mobile phones are not
able to receive files over Bluetooth until at least 5 seconds
has passed from sending.
8. Delay between multiple files [40]
If ObexSender has been configured to send multiple files, this
configuration sets the delay (in seconds) between the file
transmissions.
9. Minimum RSSI value before sending [-65]
The working range of ObexSender can be configured or limited with
this setting. When ObexSender searches for devices, the RSSI
(Receiver Signal Strength Indicator) value is also measured.
This value ranges from -128 to -1.
-128 means the signal strength is very weak. A connection attempt would
very likely fail.
-65 means the signal strength is ok. Connection can be created.
With Class 2 devices, like most mobile phones, this means the
phone is 10-20 meters away. A Class 1 device can be even more
than 100 meters away.
-30 to -1 means the signal is very strong. The devices are most likely
very close to each other (less than a meter away).
10. Logfile name [-]
Defines the path and name of the ObexSender log file
(for example "/usr/local/obexsender/obexsender.log").
Log file contains information about successful and unsuccessful
transmissions, timestamps and information about sent files.
You can also use an IP address of a log server, which must be another
Access Server running ObexSender.
Type "-" to use syslog.
11. Log prefix [-]
144