User Manual

Table Of Contents

USER'S AND DEVELOPER'S GUIDE WRAP MULTIRADIO ACCESS SERVER

Note2: the Serial Port Profile is disabled if the SMS Gateway is enabled, as they share the

same physical serial port.

1. Enable Serial Port Profile [Y]

Whether the Serial Port Profile is enabled or not.

2. Act as the Calling Device [N]

Whether this device should act as the calling device (DevA) or the answering device

(DevB).

3. BPS Rate [9600]

The bits-per-second rate of the connection. Possible values are 300, 1200, 2400, 4800,

9600, 19200, 38400, 57600, 115200, 230400, and 460800.

4. Data Bits [8]

The number of data bits in the connection. Possible values are 5, 6, 7, and 8.

5. Parity [0]

The parity bit setting of the connection. Possible values are: 0: no parity, 1: odd parity,

and 2: even parity.

6. Stop Bits [1]

The number of stop bits in the connection. Possible values are 1 and 2.

7. Hardware Flow Control (RTS/CTS) [Y]

Whether or not the hardware flow control is used in the connection.

8. Software Flow Control (XON/XOFF) [N]

Whether or not the software flow control is used in the connection.

9. Service Name (shown in SDP) [Serial Port]

The name of this service as shown in the Service Discovery. (This setting is visible only

when setting 2., "Act as the Calling device", is disabled.)

10. Bluetooth Address of the Remote Device [00:07:80:80:01:1f]

The Bluetooth address of the device to be contacted. (This setting is visible only when

setting 2., "Act as the Calling device", is enabled.)

11. Server Channel of the Remote Device [2]

The Bluetooth server channel of the device to be contacted. (This setting is visible only

when setting 2., "Act as the Calling device", is enabled.)

12. Optional Command Line Parameters for SPP Application []

Optional extra parameters for the WRAP Serial Port Profile application. Currently the

only supported parameter is "--msc", which enables transmitting of DCD/DSR status in

MSC. By default, they are not transmitted.