User Manual
Table Of Contents
- INTRODUCTION
- CONTROLLING THE ACCESS SERVER
- CONFIGURATION
- USING THE SYSTEM
- BLUETOOTH TECHNOLOGY OVERVIEW
- INTRODUCTION TO SDK
- INSTALLING THE WRAP SOFTWARE DEVELOPMENT ENVIRONMENT
- CREATING WRAP APPLICATIONS
- BLUETOOTH SERVER SOCKET INTERFACE
- I/O API
- ABOUT BLUEGIGA
- APPENDIX A – WRAP DIRECTORY STRUCTURE
USER'S AND DEVELOPER'S GUIDE WRAP MULTIRADIO ACCESS SERVER
Setting Value
Speed 115 200 bps
Data Bits 8
Parity None
Stop Bits 1
Flow Control None
Table 1. The Management Console Port Settings.
4. Connect the serial cable shipped with the Access Server to your PC's free COM port.
5. Connect the null-modem adapter shipped with the Access Server to the serial cable.
6. Connect the serial cable with the null-modem adapter to the management / user port in
the Access Server (see Figure 1).
7. Power on the Access Server.
8. Enter letter "b" in the terminal application during the first five seconds, while the blue
LEDs in the Access Server turn on one by one.
9. The management console is now activated and you should see the boot log in your
terminal window. Wait for the device to boot up and end with the prompt "[root@wrap
/]$ "
10. You are ready to control the Access Server from the management console.
2.2.2 A
CCESSING REMOTELY
When the WRAP is connected to a LAN it tries to get the IP address using DHCP by default.
One way to see the IP address of the WRAP board, connect to the WRAP with a management
console, power on the board and, after the system is up and running, give the command
"ifconfig nap". The field "inet addr" for the interface "nap" contains the IP address of the WRAP
board. For example, in the following capture from the management console, the IP address is
"10.1.1.43":
[root@wrap /]$ ifconfig nap
nap Link encap:Ethernet HWaddr 00:07:80:00:04:6C
inet addr:10.1.1.43 Bcast:10.255.255.255 Mask:255.255.255.0
inet6 addr: fe80::207:80ff:fe00:46c/64 Scope:Link
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:12635 errors:0 dropped:0 overruns:0 frame:0
TX packets:8 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:1686246 (1.6 MiB) TX bytes:1640 (1.6 KiB)
Interrupt:24 Base address:0xc000
You can use this address to connect the Access Server remotely via SSH, telnet, FTP, SFTP.
2.3 T
RANSFERRING FILES TO/FROM THE ACCESS SERVER
You can transfer file to and from the access server by default using for example:
Bluegiga Proprietary, Copyright © Bluegiga Technologies 2001-2004 12 (94)