User Manual

Table Of Contents

USER'S AND DEVELOPER'S GUIDE WRAP MULTIRADIO ACCESS SERVER

Figure 2. WRAP Multiradio Access Server LEDs.

2.2 S

HELL PROMPT ACCESS

You can get to the shell prompt using either the management console, SSH or telnet. Normally

the initial configuration, if needed, is done from the management console over the serial cable

and all further controlling activities are performed remotely using SSH or telnet sessions over

Ethernet or Bluetooth LAN / PAN connection.

If you can make SSH or telnet connections from a device that has Bluetooth LAN Access or

PAN profile support, you don’t need the management console. Just connect the Access using

LAN Access or PAN profile. The Access Server can be seen in Bluetooth inquiries as

"Wserialno_n", where "serialno" is the serial number of the device and "n" is the number of the

Bluetooth radio in guestion (model 2293 has three Bluetooth radios, any of which can be

connected). After you have connected (no PIN code / username / password needed), connect

using SSH or telnet to the device in the other end of the connection, typically 192.168.160.1.

When logging in for the first time, log in as the user "root", and enter anything for password.

2.2.1 M

ANAGEMENT CONSOLE

If you don't have Bluetooth LAN/PAN client and you don't have the Access Server connected to

your LAN or you don't know the IP address given to the Access Server, you can get the first

shell prompt access using the management console. To set up management console do the

following:

1. Have a PC with a free COM port.

2. Power off the Access Server.

3. Configure your terminal application, like HyperTerminal in Windows, to use the

following settings with the free COM port: