User Manual

Chapter 1. Usage
ASCII Interface is terminal controlled firmware which means it can be used with
any terminal emulation software, such as Hyperterminal in Windows or Minicom in
Linux. Initial port settings for ASCII interface are 115200,8n1 (baud rate 115200 bps,
8 data bits, no parity, one stop bit) and hardware flow control enabled. When you
power-on the module or evaluation kit you should see the command prompt appear
on the terminal emulation software.
After power-on you can check ASCII Interface configuration, such as Bluetooth de-
vice address, by command SET.
Example 1-1. ASCII Interface at initial state
WRAP THOR AI (version 2.0.0-rc1 build 344 $ bt1.1)
Copyright (c) 2003-2004 Bluegiga Technologies Inc.
READY.
SET
SET BT BDADDR 00:07:80:a5:c1:11
SET BT NAME WRAP AI
SET BT CLASS 001f00
SET Control BAUD 115200,8n1
SET Control ECHO 7
SET
1