User Manual

Bluegiga Proprietary Version 1.0
6
3 COMMON PHYSICAL LAYER SPECIFICATIONS
The common physical layer specifications are shown in the table below.
Item Specification
1 Operating Frequency 2400 MHz to 2483.5 MHz (In the ISM-Band)
2 Carrier Spacing 1.0 MHz
3 Channels 79
4 Duplexing TDD
5
Symbol Rate
1 Mbps
Binary one: Positive frequency deviation
6
TX Modulation Polarity
Binary zero: Negative frequency deviation
F
C
+ dF: "H"
7
RX Data Out Polarity
F
C
- dF: "L"
Table 1: Common physical layer specifications
4 GENERAL SPECIFICATIONS
The general specifications are show in the table below.
Item Specification
1 Supply voltage
WRAP THOR 2022-1-B2B
Pin 40: 3.3 V ± 0.1 V regulated voltage. (Noise < 10 mV
P-P
.)
Pin 39: 4.0 V 9.0 V unregulated voltage.
2 Supply current
WRAP THOR 2022-1-B2B
Maximum current in TX mode: 160 mA.
Maximum current in RX mode: 60 mA.
3 Frequency range
2400 MHz 2483.5 MHz. (ISM-Band.)
4 Guard band 2 MHz < F < 3.5 MHz. (Europe, Japan, USA.)
5 Carrier frequency
2402 MHz
2480 MHz. F = 2402 + k MHz; k = 0
78.
6 Modulation method GFSK, 1 Mbps, 0.5 Gaussian.
7 Hopping 1600 hops/s, 1 MHz channel space.
8 Maximum data rate
Asynchronous, 723.2 kbps / 57.6 kbps.
Synchronous: 433,9 kbps/433.9kbps.
9 Receiving signal range -82 to -20 dBm. (Typical.)
10 Receiver IF frequency 1.5 MHz. (Center frequency.)
11 Transmission power
Minimum: -18 -16 dBm.
Maximum +14
+17 dBm.
(Class 1 device with 6 power control levels.)
12 RF input impedance
50 .
13 Baseband crystal OSC 16 MHz.
14 Output interfaces 6 GPIO, PCM, SPI, UART, USB.
15 Operation temperature
273 K 328 K. (0 ºC + 55 ºC).
16 Storage temperature
233 K 358 K. (- 40 ºC + 85 ºC.)
17 Compliance Bluetooth specification, version 1.1.
18 USB specification USB specification, version 1.1.
Table 2: General specifications