User's Manual
Table Of Contents
- 1. Key Features
- 2. Pinout
- 3. Interfaces
- 4. Module Software
- 5. Hardware Design Guidelines
- 6. Electrical Characteristics
- 7. RF Characteristics
- 8. Physical Dimensions and PCB Land Pattern
- 9. Soldering Recommendations
- 10. Tape and Reel Packaging
- 11. Certifications
- 12. Ordering Information
- 13. Support
- 14. Revision History
- Table of Contents
11. Certifications
The certifications for the WGM110 Wi-Fi Module are listed in this section.
11.1 CE
The WGM110 Module is in conformity with the essential requirements and other relevant requirements of the R&TTE Directive (1999/5/
EC). This device is compliant with the following standards:
• Safety: EN 60950
• EMC: EN 301 489
• Spectrum: EN 300 328
A formal DoC is available from www.silabs.com.
11.2 FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesirable operation.
Any changes or modifications not expressly approved by Silicon Labs could void the user’s authority to operate the equipment.
FCC RF Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specif-
ic operating instructions for satisfying RF exposure compliance. This transmittermeets both portable and mobile limits as demonstrated
in the RF Exposure Analysis. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter
except in accordance with FCC multi-transmitter product procedures. As long as the condition above is met, further transmitter testing
will not be required. However, the OEM integrator is still responsible for testing their end-product for any additional compliance require-
ments required with this module installed (for example, digital device emissions, PC peripheral requirements, etc.).
OEM Responsibilities to comply with FCC Regulations
The WGM110 Module has been certified for integration into products only by OEM integrators under the following condition:
• The antenna(s) must be installed such that a minimum separation distance of 21 mm (WGM110A and WGM110E) is maintained
between the radiator (antenna) and all persons at all times.
• The transmitter module must not be co-located or operating in conjunction with any other antenna or transmitter except in accord-
ance with FCC multi-transmitter product procedures.
WGM110 Wizard Gecko Wi-Fi
®
Module Data Sheet
Certifications
silabs.com | Smart. Connected. Energy-friendly. Rev. 1.2 | 33