Installation Guide

Page 5 of 7
The MGM12P module has been certified for integration into products only by OEM
integrators under the following conditions:
• The antenna(s) must be installed such that a minimum separation distance as stated
above is maintained between the radiator (antenna) and all persons at all times.
• The transmitter module must not be co-located or operating in conjunction with any
other antenna or transmitter.
As long as the two conditions above are met, further transmitter testing will not be required.
However, the OEM integrator is still responsible for testing their end-product for any
additional compliance requirements required with this module installed (for example, digital
device emissions, PC peripheral requirements, etc.).
IMPORTANT NOTE: In the event that these conditions cannot be met (for certain
configurations or co-location with another transmitter), then the ISEDC authorization is no
longer considered valid and the IC ID cannot be used on the final product. In these
circumstances, the OEM integrator will be responsible for re-evaluating the end product
(including the transmitter) and obtaining a separate ISEDC authorization.
End Product Labeling
The MGM12P modules are labeled with their own IC ID. If the IC ID is not visible when the
module is installed inside another device, then the outside of the device into which the
module is installed must also display a label referring to the enclosed module. In that case,
the final end product must be labeled in a visible area with the following:
MODELS MGM12P02GE and MGM12P02GA:
“Contains Transmitter Module IC: 5123A-MGM12P0”
or
“Contains IC: 5123A-MGM12P0
MODELS MGM12P22GE and MGM12P22GA:
“Contains Transmitter Module IC: 5123A-MGM12P2”
or
“Contains IC: 5123A-MGM12P2
MODELS MGM12P32GE and MGM12P32GA:
“Contains Transmitter Module IC: 5123A-MGM12P3”
or
“Contains IC: 5123A-MGM12P3”
The OEM integrator has to be aware not to provide information to the end user regarding
how to install or remove this RF module or change RF related parameters in the user
manual of the end product
ISEDC (Français)
Industrie Canada a approuvé l’utilisation de cet émetteur radio (IC: 5123A-MGM12P0, IC:
5123A-MGM12P2, IC: 5123A-MGM12P3) en conjonction avec des antennes de type
dipolaire à 2.14dBi ou des antennes embarquées, intégrée au produit. L’utilisation de tout
autre type d’antenne avec ce composant est proscrite. Ce composant est conforme aux
normes RSS, exonérées de licence d'Industrie Canada. Son mode de fonctionnement est
soumis aux deux conditions suivantes :