Installation Guide

Page 4 of 7
MODELS MGM12P02GE and MGM12P02GA:
“Contains Transmitter Module FCC ID: QOQMGM12P0”
or
“Contains FCC ID: QOQMGM12P0
MODELS MGM12P22GE and MGM12P22GA:
“Contains Transmitter Module FCC ID: QOQMGM12P2”
or
“Contains FCC ID: QOQMGM12P2
MODELS MGM12P32GE and MGM12P32GA:
“Contains Transmitter Module FCC ID: QOQMGM12P3”
or
“Contains FCC ID: QOQMGM12P3
The OEM integrator has to be aware not to provide information to the end user regarding
how to install or remove this RF module or change RF related parameters in the user
manual of the end product.
ISED Canada
This radio transmitter (IC: 5123A-MGM12P0, IC: 5123A-MGM12P2 and IC: 5123A-
MGM12P3) has been approved by Industry Canada to operate with the antenna types listed
above with the maximum permissible gain indicated. Antenna types not included in this list,
having a gain greater than the maximum gain indicated for that type, are strictly prohibited
for use with this device
This device complies with Industry Canada’s license-exempt RSS standards. Operation is
subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause
undesired operation of the device
RF Exposure Statement
Exception from routine SAR evaluation limits are given in RSS-102 Issue 5.
MGM12P22GA, MGM12P22GE, MGM12P02GA and MGM12P02GE modules meets the
given requirements when the minimum separation distance to human body is 20 mm.
MGM12P32GA and MGM12P32GA modules meets the given requirements when the
minimum separation distance to human body is 35 mm.
RF exposure or SAR evaluation is not required when the separation distance is same or
more than stated above. If the separation distance is less than stated above the OEM
integrator is responsible for evaluating the SAR.
OEM Responsibilities to comply with IC Regulations