User's Manual

Bluegiga Technologies Oy
Page 10 of 30
2.1 I/O Ports
Each I/O port can be configured as an input or output. When configured as input, each I/O port, except pins
P1_0 and P1_1, can also be configured with internal pull-up, pull-down or tri-state. Pull-down or pull-up can
only be configured to whole port, not individual pins. Unused I/O pins should have defined level and not be
floating. See the Profile Toolkit developer guide for more information about the configuration.
During reset the I/O pins are configured as inputs with pull-ups. P1_0 and P1_1 are inputs but do not have
pull-up or pull-down.
2.2 UART
UART baud rate can be configured up 2 Mbps. See the Profile Toolkit developer guide for more information.
Following table lists commonly used baud rates for BLE113
Baud rate (bps)
Error (%)
2400
0.14
4800
0.14
9600
0.14
14 400
0.03
19 200
0.14
28 800
0.03
38 400
0.14
57 600
0.03
76 800
0.14
115 200
0.03
230 400
0.03
Table 4: Commonly used baud rates for BLE113