User's Manual

Page 6 of 7
ISEDC
This radio transmitter (IC: 5123A-BGM12LMA) has been approved by Industry Canada to
operate with the embedded chip antenna. Other antenna types are strictly prohibited for use
with this device.
This device complies with Industry Canada’s license-exempt RSS standards. Operation is
subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause
undesired operation of the device
RF Exposure Statement
Exception from routine SAR evaluation limits are given in RSS-102 Issue5. BGM121 and
BGM123 meets the given requirements when the minimum separation distance to human
body is less than equal to 15 mm. RF exposure or SAR evaluation is not required when the
separation distance is 15 mm or more.
BGM121A/BGM123A modules has been tested for worst case RF exposure. As
demonstrated in the SAR test report, BGM121A/BGM123A can be mounted in touch with
human body without further SAR evaluation.
If the separation distance of BGM121N or BGM123N is less than 15 mm the OEM integrator
is responsible for evaluating the SAR.
OEM Responsibilities to comply with IC Regulations
The transmitter module must not be co-located or operating in conjunction with any other
antenna or transmitter.
Radiated emission must be tested with each new host product and ISEDC must be notified
with a Class 4 Permissive Change.
OEM integrator is responsible for testing their end-product for any additional compliance
requirements required with this module installed (for example, digital device emissions, PC
peripheral requirements, etc.).
IMPORTANT NOTE: In the event that these conditions cannot be met (for certain
configurations or co-location with another transmitter), then the IC authorization is no longer
considered valid and the IC ID cannot be used on the final product. In these circumstances,
the OEM integrator will be responsible for re-evaluating the end product (including the
transmitter) and obtaining a separate IC authorization
End Product Labeling
The BGM121/BGM123 module is not labeled with IC ID because of its small physical size.
The final end product must be labeled in a visible area with the following:
“Contains Transmitter Module IC: 5123A-BGM12LMA”
or
“Contains IC: 5123A-BGM12LMA”