User's Manual
Table Of Contents
- 1. Feature List
- 2. Ordering Information
- 3. System Overview
- 4. Electrical Specifications
- 4.1 Electrical Characteristics
- 4.1.1 Absolute Maximum Ratings
- 4.1.2 Operating Conditions
- 4.1.3 Current Consumption
- 4.1.4 Wake up times
- 4.1.5 Brown Out Detector
- 4.1.6 Frequency Synthesizer Characteristics
- 4.1.7 2.4 GHz RF Transceiver Characteristics
- 4.1.8 Oscillators
- 4.1.9 Flash Memory Characteristics
- 4.1.10 GPIO
- 4.1.11 VMON
- 4.1.12 ADC
- 4.1.13 IDAC
- 4.1.14 Analog Comparator (ACMP)
- 4.1.15 I2C
- 4.1.16 USART SPI
- 4.2 Typical Performance Curves
- 4.1 Electrical Characteristics
- 5. Typical Connection Diagrams
- 6. Layout Guidelines
- 7. Pin Definitions
- 8. BGM113 Package Specifications
- 9. Certifications
- 10. Revision History
- Table of Contents
9. Certifications
9.1 Bluetooth
The Bluetooth certification for the BGM113 is pending.
QDID: TBD
9.2 CE
The BGM113 module is in conformity with the essential requirements and other relevant requirements of the R&TTE Directive (1999/5/
EC). This device is compliant with the following standards:
• Safety: EN 60950
• EMC: EN 301 489
• Spectrum: EN 300 328
A formal DoC is available from www.silabs.com.
9.3 FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesirable operation.
Any changes or modifications not expressly approved by Silicon Labs could void the user’s authority to operate the equipment.
FCC RF Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specif-
ic operating instructions for satisfying RF exposure compliance. This transmittermeets both portable and mobile limits as demonstrated
in the RF Exposure Analysis. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter
except in accordance with FCC multi-transmitter product procedures. As long as the condition above is met, further transmitter testing
will not be required. However, the OEM integrator is still responsible for testing their end-product for any additional compliance require-
ments required with this module installed (for example, digital device emissions, PC peripheral requirements, etc.).
OEM Responsibilities to comply with FCC Regulations
The BGM113 Module has been certified for integration into products only by OEM integrators under the following condition:
• The antenna(s) must be installed such that a minimum separation distance of 0 mm is maintained between the radiator (antenna)
and all persons at all times.
• The transmitter module must not be co-located or operating in conjunction with any other antenna or transmitter except in accord-
ance with FCC multi-transmitter product procedures.
BGM113 Blue Gecko Bluetooth
®
Smart Module
Data Sheet
Certifications
silabs.com | Smart. Connected. Energy-friendly. Preliminary Rev. 0.93 | 64