Daim Ntawv Qhia Tus Neeg Siv

ManualsBrandsSILICON LAB ManualsRadio BoardSILICON LABS UG185 EFR32FG1 2400/169 MHz Dual Band Radio Board

Note: For "Debug IN" to work, the kit board controller must be powered through the Debug USB connector.

8.3 Debugging During Battery Operation

When the EFR32 is powered by battery and the J-Link USB is still connected, the on-board debug functionality is available. If the USB

power is disconnected, the Debug IN mode will stop working.

If debug access is required when the target is running off another energy source, such as a battery, and the board controller is powered

down, the user should make direct connections to the GPIO used for debugging. This can be done by connecting to the appropriate

pins of the breakout pads. Some Silicon Labs kits provide a dedicated pin header for this purpose.

UG185: EFR32FG1 2400/169 MHz Dual Band Radio Board User's Guide

On-Board Debugger

silabs.com | Building a more connected world. Rev. 1.1 | 29

Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.