User manual

34 SiliconDVR Software SI 2K Manual
- After these activities are completed in disabled mode, there is another short-
cut, “Enable Write Filter and Reboot”. Selecting that will re-enable the Write
Filter and reboot. After the reboot, the Write Filter will be enabled and the
system will be ready for normal use. The state of the Write Filter (enabled or
disabled) can always be determined by opening a console window and typing
“fbwfmgr”.
Restriction when using USB storage for recording
There is a conflict between the BIOS setting of the SI-2K camera and the Write
Protection Filter on the system drive (CF Card - path c:\). So when attaching
an additional USB recording Device (like a USB thumb drive/ USB stick/ USB
HDD) besides the SATA drive in the internal 2.5“ Drive slot AND rebooting the
system, the Write Protection for the system drive (CF Card - path: c:\) of the
SI-2K gets mixed up. At the same time recording onto that additional USB stor-
age device is not possible.
Solution
If you want to use additional USB recording devices on the SI-2K please al-
ways add and remove them on and from the RUNNING SYSTEM (hot plug).
Do NOT perform a reboot with any USB storage device attached to the SI-
2K!!
Cineform RAW™ Encoder
For the SI-2K Digital Cinema Camera, the encoder will already be activated at
the factory and nothing else needs to be done by the user. Up to 3 computers
can be activated for recording at one time. Activations can be removed at the
registrations website.
For the PC user, after the SiliconDVR software is installed, there will be a
CineForm directory added to the start menu. A program called ActivateRAW
must be run on the machine that will do the capturing. ActivateRAW will create
a system code (“finger print”) for this computer. Then, go to the registration
site: http://www.cineform.com/register.html and enter this system code
(“finger print”), serial number, company name, and e-mail address. An activa-
tion key will be e-mailed to the email address provided. Enter the Name and
Activation Code into the ActivateRAW dialog EXCACTLY as they appear in the
activation e-mail you received, and an activation confirmation message should
appear. If the encoder is updated there should be no need to reactivate the
new version.