User guide

ezRAID3 Manager GUI Version 1.0
2. At a command prompt, type diskpart.
3. Type list volume to display the existing volumes on the computer.
4. Type select volume <volume_number> where “<volume_number>” is
number of the volume that you want to extend. In this case that will be “2”.
5. Type extend
6. Type exit to quit Diskpart.exe
The volume size will be updated to reflect the expanded physical storage capacity while
maintaining all of the existing data that is stored on the volume.
The result of extending the hard disk partition/volume is illustrated below.
Before
extend:
After extend:
ezRAID3 RAID Manager User's Guide
Page 93