Silfab Installation Manual

Important note: Disclaimer of liability

Silfab PV Modules have successfully passed IEC

61701:2011 – Level 5 Salt Mist Corrosion Test. Howev-

er, full protection against salt exposure is largely depen-

dent on multiple components of the PV system beyond

Silfab’s control. As such, Silfab can strongly recom-

mends to adhere to the installation procedure. If negli-

gence is found, Silfab cannot hold responsibility and

disclaim liability for any loss, damage, or expense arising

out from “near-coastal” installation.

13.6 Recycling Packaging Materials

Silfab undertakes efforts to treat every aspect of

production to minimize the environmental impact. The

packaging is made with materials that for the most

part are reusable.

In particular, the wooden pallets (Fig.11) and protec-

tive corners (Fig.12) should be retained. Arrange-

ments for recovery will be made on a case by case

basis.

Fig.11

Fig.12

Fig. 11 & 12: How to package the pallets and plastic

corners, respectively, after unloading, ready to deliver

back to Silfab for reuse.

Document Number: MAN-SFO-06 | SAFETY AND INSTALLATION MANUAL FOR PHOTOVOLTAIC MODULES