Datasheet

SET PORT S1 FLOW <flowcontrol> [where <flowcontrol> is NONE, XON/XOFF,
CTS, or DSR]
The console commands are summarized in Appendix B of this manual.
6. When you have finished entering commands type:
INIT
EXIT
These commands will save the configuration and restart the unit. You are now ready to use the
SX-550.
EXIT
7. After an IP address is configured in the SX-550, you can also access the Internal Command
Console in any of the following ways:
• TELNET. From the Windows Command Prompt (MS-DOS Prompt), Mac OS X Terminal
Utility, or UNIX/Linux command line, enter the command:
telnet aa.bb.cc.dd
where aa.bb.cc.dd is the IP address of the SX-550. Press <ENTER> and then enter the
password access at the # prompt. Press <ENTER> at the Enter Username> prompt and
you are now ready to enter console commands.
• Internal Web Pages. Use a web browser to connect to the SX-550 internal web pages as
described earlier in this chapter. After you have logged in, click Admin on the left side of
the screen, and then click Console. You can now enter console commands (you must
click Enter after each command).
• ExtendView. Select the desired SX-550 from the ExtendView main menu. Click Tools
on the menu bar, and then click Telnet Session. Press <ENTER> and then enter the
password access at the # prompt. Press <ENTER> at the Enter Username> prompt and
you are now ready to enter console commands.
Part Number 40183-101 Silex SX-550 Developer's Guide Page 31
IMPORTANT: The console command EXIT must always be used in order to save the changes you made with the
internal command Console.