Datasheet

SH POWER Shows the current power control mode.
Firmware Update
Table 42 Firmware Update
Command Description
SET LOAd ENable Sets the firmware to perform a soft reset and enter the server boot program after the
next Exit command.
This command is used for diagnostic purposes only.
The default value is Disable.
Format:
SET LOAd (ENable | DIsable ]
SET LOAd HOst Sets the node name of the Netware boot host.
This command is used for diagnostic purposes only.
The default value is null>\
Format:
SET LOAd HOst <name>
SET LOAd IP Sets source computer IP address for TFTP get operation.
The default value is 0.0.0.0.
Format:
SET LOAd IP aa.bb.cc.dd
SET LOAd SOftware Sets filename on host for TFTP get update
Format:
SET LOAd SOftware <filename>
SET LOAd TFTP Initiates firmware update using TFTP get operation.
The TFTP server address must be set using SET LOAd IP and the filename using
SET LOAd SOftware. The server will reset after the firmware update is completed.
Format:
SET LOAd TFTP
SET LOAd XModem Initiates firmware update using the XModem protocol on the serial console
The server will reset after the firmware update is completed.
Format:
SET LOAd XModem
SH LOAd Shows the firmware update parameters
Sample output:
Firmware load is disabled
Load Host IP = 0.0.0.0
Part Number 40183-101 Silex SX-550 Developer's Guide Page 100