Datasheet

Command Description
17 00020000 GPIO Trigger2: GPIO2 0 to 1
18 00040000 GPIO Trigger3: GPIO3 0 to 1
19 00080000 GPIO Trigger4: GPIO4 0 to 1
20 00100000 GPIO Trigger5: GPIO5 0 to 1
21 00200000 GPIO Trigger6: GPIO6 0 to 1
22 00400000 GPIO Trigger7: GPIO9 0 to 1
23 00800000 GPIO Trigger8: GPIO10 0 to 1
24 01000000 GPIO Trigger9: GPIO1 0 to 1
25 02000000 GPIO Trigger10: GPIO2 1 to 0
26 04000000 GPIO Trigger11: GPIO3 1 to 0
27 08000000 GPIO Trigger12: GPIO4 1 to 0
28 10000000 GPIO Trigger13: GPIO5 1 to 0
29 20000000 GPIO Trigger14: GPIO6 1 to 0
30 40000000 GPIO Trigger15: GPIO9 1 to 0
31 80000000 GPIO Trigger16: GPIO10 1 to 0
Bridge mode configuration
Command Description
SET NW BRIDGE ENA Sets the device to bridge a single connected device. In this mode, only
TCP/IP (Telnet, HTTP) can be used to configure the Silex device.
SET NW BRIDGE DIS
Disables bridging mode returning the unit to normal operation
SET NW BRWIRED
ENA
Enables the wired interface as the active configuration interface. This is
used for connecting to a PC via the wired port, typically to set up the
wireless parameter.
SET NW BRWIRED
DIS
Enables the wireless interface as the active configuration interface. This
is the normal setting when bridge mode is active, as the wired port will be
connected to the device being bridged, which will usually not be
configuration the Silex device.
Power Configuration Commands
Table 41 Power Configuration
Command Description
SET POWER LEVEL n Sets the power save mode. High power is for fastest throughput,
low power is for lowest power consumption.
Set POWER LEVEL 0, 1 or 2
0 = High Power
1 = Medium Power
2 = Low Power
Part Number 40183-101 Silex SX-550 Developer's Guide Page 99