Network Card User's Manual

Console Commands silex Page 69
Part Number 40183-101
Command Description
The default value is 3.
Sample output:
SET IP BOot n
SET IP ENable Enables or disables all IP based protocols
The value is Enable.
Sample output:
SET IP [ENable | DIsable]
SET IP FTIme Sets IP timeout
If enabled, the IP timeout is measured in seconds. If disable, the IP timeout is in
minutes.
The default value is Disable.
Sample output:
SET IP FTIme [ENable | DIsable]
SET IP FTP Enables or disables FTP protocol
The default value is Enable.
Sample output:
SET IP FTP [ENable | DIsable]
SET IP HTTP Enables or disables HTTP protocol
The default value is Enable.
Sample output:
SET IP HTTP [ENable | DIsable]
SET IP KEepalive Sets interval in minutes for sending TCP keepalive packets on a connection
The default value is 5 minutes.
Sample output:
SET IP KEepalive n
SET IP LPD Enables or disables the LPD protocol
The default value is Enable.
Sample output:
SET IP LPD [ENable | DIsable]
SET IP MEthod Sets method of getting IP address
The default value is Auto.
Sample output:
SET IP MEthod [ AUTO | BOOTP | RARP | DHCP | STATIC ]
SET IP PIng Sends IP ping packets to test connection to remote host
Sample output:
SET IP PIng aa.bb.cc.dd
SET IP PRObe Enables or disables TCP connection probes
The default value is Disable.