User`s guide

138
SX-AP-4800AN User's Guide
Wireless LAN - Security Conguration
Privacy Separator
General Conguration
-
Detail Conguration
*
Details Allow/Deny communication among the wireless client devices connected to SX-AP-4800AN.
If the privacy separator is enabled on the wireless interface, wireless frames are not forwarded to the
other wireless interfaces. It is only forwarded to a wired LAN interface.
Range ON/OFF
Default Value OFF
Wireless LAN - WDS Conguration
WDS Mode
General Conguration
*
Detail Conguration
*
Details Set the WDS operation mode to make communication between the Access Points.
The WDS network consists of one Root AP (host) and plural Repeater APs (client).
Range DISABLE/Root AP/Repeater
Default Value DISABLE
Note DISABLE:
Does not use WDS.
Root AP:
Runs as Root AP for WDS.
This exchanges trac among Repeater, wired LAN and wireless client device.
Repeater:
Runs as Repeater for WDS.
This exchanges trac among Root AP, Repeater, wired LAN and wireless client device by connecting
to Root AP or Repeater.
Wireless Interface
General Conguration
*
Detail Conguration
*
Details Select the wireless interface for WDS to make communication between the Access Points.
Range 1/2/3/4
Default Value 1
Note The MAC Address displayed under the Wireless Interface is the MAC Address of SX-AP-4800AN to use for
WDS. This information will be used on Repeater AP which sets SX-AP-4800AN as a host AP.
Access Point MAC Address
General Conguration
*
Detail Conguration
*
Details Set the MAC Address for Root AP or Repeater AP to connect as host AP in WDS mode.
Range 00:00:00:00:00:00 - FF:FF:FF:FF:FF:FF
Default Value 00:00:00:00:00:00
Note This setting is not necessary on Root AP.
The MAC Address for Root AP or Repeater AP to connect as a host AP in WDS can be seen on the
Web page of the host AP. Log in to the Web page of the host AP and click Wireless LAN - WDS
Conguration - Wireless Interface. The MAC Address will be displayed under the Wireless Interface.