System information

33Appendix
Users Manual RX
SNMP
Filter Mode DENY Specify the filter mode.
Filter #0 Start
Address
0.0.0.0 Specify the filter start Address.
Filter #0 End
Address
0.0.0.0 Specify the filter end Address.
Filter #1 Start
Address
0.0.0.0 Specify the filter start Address.
Filter #1 End
Address
0.0.0.0 Specify the filter end Address.
Filter #2 Start
Address
0.0.0.0 Specify the filter start Address.
Filter #2 End
Address
0.0.0.0 Specify the filter end Address.
Filter #3 Start
Address
0.0.0.0 Specify the filter start Address.
Filter #3 End
Address
0.0.0.0 Specify the filter end Address.
Factory Default Explanation
Authentic Community "Public" Setup SNMP authentic community name. This community
name is authenticated when receiving SNMP Set Request.
Trap Community "Public" Enter TRAP community name. This name will be used when
the PRICOM executes a trap.
Trap Address (IP) 0.0.0.0 Enter the TRAP address. The TRAP address is disabled if
the IP address is set 0.0.0.0.
SysContact "" Enter SysContact for MIB-II object. Normally enter
administrator’s mail address.
SysName "" Enter SysName for MIB-II object. Normally enter the
PRICOM’s host name or domain name.
SysLocation "" Enter SysLocation for MIB-II object. Normally enter location
where the PRICOM is located.
EnableAuthenTrap 2 Enable or disable authenticate trap for MIB-II. When enabled,
in occurrence of community error, a SNMP trap will be sent
to the address set at “Trap Address”.
- Communication from a designated range of IP addresses can be blocked when Filter Mode is
set to "DENY." On the other hand, when Filter Mode is set to "ALLOW," communication from
only a designated range of IP addresses can be enabled.
NOTE