System information

32Appendix
Users Manual RX
Parameter Configuration
After you have finished installing the PRICOM R-9100U, you need to configure the functions.
Below are the explanations on how to configure the PRICOM R-9100U.
General
TCP/IP
Factory Default Explanation
Change root
Password
none
(no password)
Set up a password for the administrator. This password will
be used for Telnet, Web page, and setup utility.
LAN Interface AUTO Set up the LAN interface. Normally use in AUTO. If you see
no blinking on the HUB after you turn on the PRICOM,
change to appropriate type.
Factory Default Explanation
DHCP/BOOTP ENABLE Enable or disable DHCP/BOOTP. This is a protocol which
acquires an IP address from DHCP/BOOTP server when
booted. In order to use this function with the PRICOM, a
DHCP/BOOTP server must exist in the network and properly
set up. the PRICOM will automatically acknowledge.
RARP ENABLE Enable or disable RARP. RARP is a protocol which acquire
IP address from RARP server when booted. In order to use
this function with the PRICOM, a DHCP/BOOTP server must
exist within the same subnetwork and properly set up.
IP Address 0.0.0.0 Set up an IP address. The value must be configured in the
format of four part series of numbers separated by decimal
points, such as “xxx.xxx.xxx.xxx”.
Subnet Mask 0.0.0.0 Set up a subnet mask. The value must be configured in the
format of four part series of numbers separated by decimal
points, such as “xxx.xxx.xxx.xxx”. The gateway must reside
within the same subnetwork as the PRICOM. If you set as
0.0.0.0, this section will be invalid.
Default Gateway 0.0.0.0 Set up a gateway IP address. The parameter should be a
decimal that looks like “xxx.xxx.xxx.xxx”. Gateway must
reside within the same subnetwork as the PRICOM. If you
set as 0.0.0.0, this section will be invalid.