System information

29Appendix

Users Manual RX

About TELNET

After assigning an IP address to the PRICOM R-9100U, parameters can be configured with

TELNET in your TCP/IP or SNMP software. TELNET allows you to display and set parameters

for the PRICOM R-9100U by using the following commands. Below are some examples.

- Only one PRICOM unit can be connected with a PC over TELNET.

- The MS-DOS Prompt or Command Prompt embedded in the Windows operating system can be

used to connect with the PRICOM unit over TELNET. For Windows 95/98/Me/NT 4.0 users, go

to Start, Programs, then activate MS-DOS Prompt. For the Windows 2000/XP/Server 2003

users, go to Start, All programs-Accessories, then activate the "Command prompt".

Example of display when logged in using TELNET

PRICOM R-9100U Ver x.x.x TELNET server.

'root' user needs password to login.

password:

User 'root' logged in.

No. Item Value (level.1)

----------------------------------------------------------------------

1 : Configure General

2 : Configure TCP/IP

3 : Configure SNMP

96 : Display Status

97 : Reset Settings to Defaults

98 : Restart Print Server

99 : Exit

Please select(1 - 99)?

Connecting with the PRICOM R-9100U over TELNET

Command to connect with the PRICOM R-9100U over TELNET

telnet xxx.xxx.xxx.xxx

(IP Address)

NOTE

TIP