System information

28Appendix
Users Manual RX
1. Log in to the PRICOM via a web
browser, then go to the "TCP/IP" tab.
2. Enter the necessary parameters at "IP
filter Configuration" in the "TCP/IP"
item. For this case, enable "ALLOW"
at the Filter Mode, then enter
192.168.20.1 and 192.168.20.50 for
both "Start Address" and "End
Address" area respectively.
IP filtering
Other functions
- For further details on how to use the PRICOM R-9100U Web browser, TELNET or the procedure
to change the PRICOM R-9100U configuration, refer to "Connecting with the PRICOM R-9100U
using a Web browser" or "About TELNET" in this section.
The PRICOM can define scopes of IP addresses to allow or deny communication. When
setting up for "DENY", communications from the designated IP address scope will be prohibited.
When setting up "ALLOW", communication will be allowed only from the designated IP
addresses. Up to 4 IP address scopes can be registered for the DENY/ALLOW functions. IP
filtering can protect illegal access from unexpected network client users.
NOTE
This chapter explains other functions about the PRICOM R-9100U. A web browser or TELNET
is required for configuration.
(Example)
To allow access from the IP address scope between 192.168.20.1-192.168.20.50 using a web browser;