Instruction manual

Users Manual CX
19
Appendix
Parameter Configuration
After you have finished installing the PRICOM, you need to configure the functions.
Below are the explanations on how to configure the PRICOM.
GeneralGeneral
GeneralGeneral
General
TCP/IPTCP/IP
TCP/IPTCP/IP
TCP/IP
CD-ROM Setup Telnet Web page
Change root
Password
Change root
Password
none
(no password)
Setup password for administrator. This password will be
used for Telnet, Web page, and setup utility.
Use HP
JetAdmin
Use HP
JetAdmin
YES Enable or disable using Hewlett Packard's utility
JetAdmin/Web JetAdmin.
LAN Interface LAN Interface AUTO Setup network type. Normally use in AUTO. If you see
no blinking on HUB after you turn on PRICOM, change
to appropriate t
y
pe.
Factory DefaultName Explanation
CD-ROM SetUP Web page AdminManager
TCP/IP Protocol TCP/IP Protocol Use TCP/IP
Protocol
ENABLE Enable or disable TCP/IP protocol. This section influence
LPR, FTP, TELNET, SNMP, HTTP and Setup utility (for
TCP/IP).
Receive IP
address
automatically
DHCP/BOOTP Use
DHCP/BOOTP
ENABLE Enable or disable DHCP/BOOTP. This is a protocol which
acquire IP address from DHCP/BOOTP server when booted.
In order to use this function with PRICOM, a DHCP/BOOTP
server must exist in the network and properly set up.
PRICOM will automatically acknow
RARP Use RARP ENABLE Enable or disable RARP. RARP is a protocol which acquire
IP address from RARP server when booted. In order to use
this function with PRICOM, a DHCP/BOOTP server must
exist within the same subnetwork and properly set up.
IP Address IP Address IP Address 0.0.0.0 Setup IP address. The value must be configured in the
format of four part series of numbers separated by decimal
points, such as “xxx.xxx.xxx.xxx”.
Subnet Mask Subnet Mask Subnet Mask 0.0.0.0 Setup subnet mask. The value must be configured in the
format of four part series of numbers separated by decimal
points, such as “xxx.xxx.xxx.xxx”. The gateway must reside
within the same subnetwork as PRICOM. If you set as
0.0.0.0, this section will
Default Gateway Default Gateway Default Gateway 0.0.0.0 Setup gateway IP address. Parameter should be a decimal
that looks like “xxx.xxx.xxx.xxx”. Gateway must reside within
the same subnetwork as PRICOM. If you set as 0.0.0.0, this
section will be invalid.
Factory DefaultName Explanation