Instruction manual

Users Manual CX

Appendix

Test Report and Parameters of PRICOM C-5100 and

PRICOM C-6100U

Diagnostic/Configuration Report

-Diagnostic/Configuration report is not available with Canon Bubble Jet Printers.

-To print a Diagnostic/Configuration report, make sure the printer and the PRICOM is off.

The Diagnostic/Configuration report can be printed when PRICOM is turned on while

connected to the printers that carry their own fonts. During the diagnostic check, the

PRICOM tests the hardware and the network, so this may help you to detect an error.

How to do the Diagnostic/Configuration report, please refer to "II. About PRICOM".

Diagnostic Report (In case of PRICOM C-5100)

You can print hardware function check pages when you turn on PRICOM .

PRICOM C-5100 Version 2.0.0

*** Diagnostic report ***

ROM Check: Ok stat: xxxx FFFF 0000 0000

RAM Check: Ok stat: 0000 0000 0000 0000

NIC Check: Ok addr: 00:80:92:12:34:56 100BASE-TX

EEPROM Check: Ok stat: xxxx xxxx 0000 0000

DIPSW1 : OFF(ON: Test use only)

DIPSW2 : OFF(ON: Initialize configuration)

DIPSW3 : ON (ON: Diagnostic/Configuration print)

DIPSW4 : OFF(ON: Reserved)

TIP