Instruction manual
5-4
Questions & Answers
Users Manual CX
How to check PRICOM configuration status
Configuration status can be obtained from diagnostic/configuration report with PRICOM
C-5100 and C-6100U. However this is available only with printers that carry their own
fonts. For more information on diagnostic/configuration report, refer to chapter “II. About
PRICOM” of this on-line manual.
Diagnostic/configuration report is not available with PRICOM C-700.
How to initialize / reset PRICOM to factory default
-Both PRICOM C-700, PRICOM C-5100, PRICOM C-6100U can be initialized / reset to
factory default via the PRICOM User Software CX or Telnet. To initialize PRICOM via
the PRICOM User Software CX, select “Set Up” – “Install printing software and PRICOM”
– “Initialize”. To initialize PRICOM via Telnet, refer to "Appendix" of this manual.
-PRICOM C-5100 can be initialized by using the Dip switch. For further information on
how to initialize using the DIP switch, refer to chapter “II. About PRICOM”, “Section 2:
PRICOM C-5100”, “Parts and Functions”.
-PRICOM C-6100U can be initialized by using the Push switch. For further information
on how to initialize using the Push switch, refer to chapter “II. About PRICOM”, “Section
3: PRICOM C-6100U”, “Parts and Functions”
PRICOM is initialized everytime the power is turned on
(In case of PRICOM C-5100)
Make sure that the PRICOM C-5100 DIP switch is not set to "initialize". For further
information on how to operate the DIP switch, refer to chapter “II. About PRICOM”,
“Section 2: PRICOM C-5100”, “Parts and Functions”.
The Status Monitor may not be available depending on the driver version you are using.
Download the latest driver to use the status monitor.