Silex technology PRICOM PRICOM C-700 : Instruction manual : Page 37

Users Manual CX

3-2

Using PRICOM in a Windows Environment

How to Setup PRICOM

The setup of PRICOM in a Windows NT 4.0, Windows 2000 or Windows XP should be done

through administrator rights.

There are three setup methods available under the PRICOM User Software CX.

Setup Mode 1:

"Install printing software and PRICOM" "Install printing software and PRICOM"

"Install printing software and PRICOM"

-Using TCP/IP Protocol(recommended)-Using TCP/IP Protocol(recommended)

-Using TCP/IP Protocol(recommended)

This method sets up PRICOM and the printing software. You must choose this setup

mode, when you are using PRICOM for the first time and the product is still in factory

default.

For further information on this setup mode, please refer to pages 3 (3-3) ff.

Setup Mode 2: "

Install printing software"Install printing software"

Install printing software"

-Install Printing Client Software-Install Printing Client Software

-Install Printing Client Software

This method sets up only the printing software. You should choose this setup mode,

when PRICOM has already been setup in the environment.

For further information on this setup mode, please refer to pages 11(3-11) ff.

Setup Mode 3: "

Install IPX protocol and printing software automatically"Install IPX protocol and printing software automatically"

Install IPX protocol and printing software automatically"

-Using IPX Peer to Peer Protocol-Using IPX Peer to Peer Protocol

-Using IPX Peer to Peer Protocol

This method sets up only the very essential options via the IPX Peer to Peer protocol and

is the easiest way to setup PRICOM. You only need to answer a few questions and the

installation is completed. When choosing this setup mode, the IPX protocol is being

used, the TCP/IP protocol is not being used.

For further information on this setup mode, please refer to pages 17(3-17) ff.

TIP