Instruction manual

2-18About PRICOM

Users Manual CX

(Bottom)

-Ethernet Address

The Ethernet Address of the device. The last 6 digits are the product’s serial number.

-Ethernet Address 00:80:92:18:0E: 1A is noted as 008092180E1A.

-The product’s number (serial number) is 180E1A.

(Back)

-Network Port (10BASE-T/100BASE-TX)

Connect to the network cable. In 100BASE-TX environment, use category 5.

-USB Port

Connect to the USB cable.

-Power Connector

Connect to the AC adapter.

(Right Side)

-Push Switch

By pushing this switch, you can initialize PRICOM to factory default and print Diagnostic/

Configuration report.

1. Make sure that the AC adapter is not connected to PRICOM C-6100U.

2. While pushing the push switch, connect the AC adapter to PRICOM C-6100U.The STATUS LED

will blink once when the connection is made.

3. Continue to push the push switch for two seconds. The STATUS LED will blink again when

factory default is successfully completed. Remove your hand from the push switch.

While PRICOM is in use, push on the push switch for more than 5 seconds. The test print will be

executed. This is available only with printers with fonts.

-Do not turn off the power to PRICOM C-6100U while it is initializing to factory default.

-When PRICOM is turned on again after factory default is completed or the Diagnostic/

Configuration report is executed, do not push on the push switch.

-Factory default can be executed from the PRICOM User Software CX. For further

information, refer to Chapter “III. Using PRICOM in a Windows Environment” of this on-

line manual.

-Diagnostic/Configuration report is not available with Canon Bubble Jet Printer. Do not

use the push switch function.

NOTE

TIP