Instruction manual

2-11About PRICOM
Users Manual CX
Connect PRICOM C-5100 to the Printer
-Before connecting PRICOM C-5100 to the printer, make sure that the power cord of the
printer is unplugged.
-If you have already used PRICOM C-5100 in another network, make sure to initialize
PRICOM C-5100 to factory default. You can initialize PRICOM C-5100 from PRICOM
User Software CX. For further information, refer to chapter “III. Using PRICOM in a
Windows Environment” of this on-line manual.
Hardware Installation
TIP
1. Make sure that the printer is
switched off and unplug the power
cord of the printer. Attach PRICOM
to the parallel interface port of the
printer.
Make sure that the AC adapter is not
connected to PRICOM at this time.
2. After PRICOM and the printer have
been connected, make sure that the
printer is still switched off. Then
plug the power cord of the printer
into a power socket.