Instruction manual

2-10About PRICOM
Users Manual CX
-Do not turn off the power supply until the LINK LED lights during initialization of PRICOM.
-Do not turn off the power supply until the diagnostic report is completed during diagnostic
report of PRICOM.
-When normal operating setting, make sure that all dip switches are off.
-You can initialize PRICOM C-5100 from PRICOM User Software CX. For further
information, refer to chapter “III. Using PRICOM in a Windows Environment” of this on-
line manual.
-Diagnostic report is not available with Canon Bubble Jet Printers. Do not use any dip
switches.
(Back)
-Network Port (10BASE-T/100BASE-TX)
Connects to the network cable.
-10BASE LINK LED(Green)
Lights when a proper 10BASE-T network connection is established.
-100BASE-TX LINK LED(Green)
Lights when a proper 100BASE-TX network connection is established.
-STATUS LED(Orange)
Lights while the power is supplied. Flashes during data transfer.
-Power Connector
Connects to the AC adapter.
TIP