User's Manual

FCC Notice

This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired operation.

List of applicable FCC rules

This device complies with below part 15 of the FCC Rules.

Part 15 Subpart C

Part 15 Subpart E

Test Modes

silex technology, Inc. uses various test mode programs for test set up which operate separate from production

firmware. Host integrators should contact silex technology, Inc. for assistance with test modes needed for

module/host compliance test requirements.

Additional testing, Part 15 Subpart B disclaimer

The modular transmitter is only FCC authorized for the specific rule parts (i.e., FCC transmitter rules) listed on the

grant, and the host product manufacturer is responsible for compliance to any other FCC rules that apply to the host

not covered by the modular transmitter grant of certification.

The final host product still requires Part 15 Subpart B compliance testing with the modular transmitter installed.

Summarize the specific operational use conditions

This module designed for mounting inside of the end product by end product manufacturer professionally.

Therefore, it complies with the antenna and transmission system requirements of §15.203.

RF exposure considerations

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and meets the

FCC radio frequency (RF) Exposure Guidelines. This equipment should be installed and operated keeping the radiator

at least 20cm or more away from personʼs body.

Co-Location Rule

This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.

Label and compliance information

Following information must be indicated on the host device of this module.

Contains Transmitter Module FCC ID：N6C-PCEACDBR2

Contains FCC ID：N6C-PCEACDBR2