Product specifications

Serial Port 2). Enter admin when you get the login: prompt, and then enter the password access.
Then enter the command console in response to the Linux # prompt.
3. When you see the Local> prompt, you can enter commands (note that this command may take
up to 30 seconds to appear if you are using Serial Port 2). The SX-560 is set by default to use
DHCP to obtain the IP address automatically. If you want to set the IP address manually, enter
the following commands:
SET IP ADDRESS aa.bb.cc.dd
SET IP SUBNET aa.bb.cc.dd
SET IP ROUTER aa.bb.cc.dd
where aa.bb.cc.dd is the IP address of the SX-560. You can use the command SHOW IP to
verify the IP address settings.
4. Enter the basic wireless settings as follows:
SET NW SSID <name> [where <name> is the SSID for your network]
SET NW MODE <mode> [where mode is INFRASTRUCTURE or
AD-HOC]
SET NW CHANNEL n [where n is 1 to 11; this is only required for
AD-HOC MODE]
5. Use the appropriate SET NW command to set wireless encryption mode and authentication type
(check with your network administrator for the proper settings if you do not know them):
SET NW ENC <mode> [sets encryption mode, where <mode> is WPA,
WPA2, 64, 128, or WPA2-WPA]
SET NW AUTHTYPE <type> [sets authentication type, where <type> is
OPEN, SHARED, TTLS, PEAP, WPA-PSK,
LEAP, TLS, or FAST].
For WPA2-PSK or WPA, enter the command:
SET NW WPAPSK <psk> [sets pre-shared key for WPA2 or WPA, where
<psk> is the key]
SET NW WPAGROUP <state> [enables or disables WPA group key mode,
where <state> is ENABLED or DISABLED;
default is DISABLED]
For WEP (WEP64 or WEP128), use the following commands:
SET NW KEYVAL <key> [Sets WEP key, where <key> is 10 hex
characters for WEP64 or 26 hex characters for
WEP128]
SET NW KEY# n [sets the number of the WEP key that will be
used as the transmit key, where n=1 to 4; default
value is 1]
Configuring 802.1X EAP authentication can be complex. Please refer to Appendix A and/or
Appendix B for details of the required commands.
Note: Early versions of the SX-560 firmware require you to login as root with the password access, and to enter command
./console to access the console.