User's Manual

User’s Guide
Document #40171-120 Rev. AX1 3
Print Server Components
The PocketPro USB print server includes the following components.
Detailed descriptions of these components are provided below:
 Power connector – The power supply cable plugs into this
connector.
 Test button – Pressing this button for less than three seconds will
print a test page on the printer. Pressing and holding this button
for more than five seconds will reset the print server to factory
default settings.
 LED status indicators – used to indicate the operational states of
the print server. Refer to page 8 in this user’s guide for detailed
LED status light descriptions.
 Ethernet Port – This port is used for connecting the PocketPro
USB to an Ethernet card, hub, router, or other wired access point
for network access.
 USB port – This port is used for connecting the PocketPro USB
port to a USB printer. You must use a standard USB A (print
server side) to B (printer side) cable.