Installation Manual

Test

STOP switch:

If a stop switch from a previous installation is installed in the connection cable at

the AC- or DC-side ot the charge controller, it must always be removed or

secured against switching off. The activation of the stop switch while the

windgenerator is running will immediately destroy the windgenerator or the

charge controller.

Wiring:

All cables connected in line with plan? Check the polarity of all wires i

n the

screw connection poles. Is the 3-phase cable of the SILENTWIND

connected to

the charge controller? Are the cables correctly crimped and is

the strain relief

inserted?

Yaw shaft:

Is the rubber pad well placed?

Rotor blades:

Mounted in line with instructions?

Assembly hub:

Is the assembly hub fixed to the generator shaft? Is the central sc

rew nut

fastened with 30 Nm?

Connect to a 3-phase rectifier (optional) or the included charge controller. Please

read the charge controller manual for details on its installation.

Now you can go ahead!

9. Run and Stop

Switch the enclosed stop-switch or the stop-switch of the charge controller to position

“RUN”. If the wires are correctly connected to the battery (without having mixed up

the polarity) the SILENTWIND should start charging if windspeed is sufficient. You

can control this on the LCD-display of the charge controller.

10. Charging indicator

A blue LED at the bottom of the windgenerator-body shows you if the generator is

producing electrical energy. The charging-amount is shown on the display of the

charge controller.

11. Check ups

Your SILENTWIND was constructed for long term use without any maintenance.

However, simple and regular check ups ensure the necessary security.