Installation manual

18
Wind generator doesn´t charge:
Not enough wind
Electric wiring interrupted
Fuse is blown
Carbon brushes in the yaw bearing
have no contact
Possible cause
Measure the wind speed at the rotor.
(Wind speed on the main mast-top
may be higher)
Check wires, connections and gadgets
Check fuse
Check carbon brushes and springs
Test
Start up of charging depends on the
battery status, check the adjustment of
the charge controller
Replace damaged wires or gadgets
Replace fuse or cool down the
automatic circuit breaker
Replace carbon brushes and reactivate
springs
Solution
Battery is not fully charged:
Old, damaged battery deficient
Fuse blown
Charge controller wrongly installed
Charge controller stop-switch is in
position STOP
Deficient generator
Deficient charge controller, mix up of
polarity
Possible cause
Test battery status and liquid of every
battery
Check fuse
Check in line with manual
Switch stop switch in position RUN
Check AC voltage, AC screw terminals
Check adjustments according to
instructions
Test
Replace battery,
refill destilled water (not necessary for
gel- or AGM-battery)
Replace fuse,
find cause of deficiences
Correct installation
Observe manual instructions
Check all 3 AC cables after
disconnecting from charge controller as
to short circuit
Repair customer service / replacement
Solution