User Guide

Instructions
1. Screw in all four rubber silencers in the
side gaps of the cooler-case. The back side
of the cooler case is marked with a dot.
2. Stick the self-adhesive silicon-film
(15x15 cm) on the inside the cooler-case.
For this pull off ¼ of the film and stick it
precise at the back side of the cooler-case.
Now stick the silicon-film inside the cooler-
case by pulling it off continuously.
3. Screw on the side-frame at the front of
the cooler-case using 2 black M3 screws
supplied. Do not over tighten until all the
screws are in place and then tighten with a
screwdriver.
silentmaxx HD-silencer - 4 -
®
silentmaxx HD-silencer - 3 -
®
Scope of supply
side-frame
without recess
ground cable
with two
lock washers
silencer (4x)
thumbscrew (2x)
cover-spacer
silicon-film
screws M3
for cover-spacer (4x)
HD-spacer
cooler-case
silicon-film
side-frame
with
recess
cover-sheet
screws M4
for PC-case (4x)
side-frame
without
recess
screws M3
for side-frame
without recess (2x)