User guide

16 IP Communicator Series Installation Document — P/N 53109:I 4/26/2010

2.4 Mounting 411 or 411UD in HP300ULX Power Supply Enclosure with

IPDACT Series

The 411/411UD can be mounted inside the HP300ULX power supply enclosure as described below.

1. Position the two mounting tabs on the 411/411UD, over the two mounting holes in the HP300ULX backbox. Use

dimensions and the landmarks illustrated in Figure 16 to locate the correct mounting location.

2. Secure the 411/411UD to the backbox by installing the supplied screws into the top and bottom mounting tabs of the

411/411UD and tighten. Refer to Figure 17.

3. Install the IPDACT Series in the HP300ULX enclosure as described in Section 2.3 of this document.

411/411UD

mounting

holes

Figure 16 411/411UD Installation

HP300ULXinstall411UD.wmf

411/411UD DACT

mounting tab

Figure 17 411/411UD Installation

HP300ULXinstall411UD2a.wmf