Manual

P/N 151088

Silent

Knight

By Honeywell

5865-3 and 5865-4 Installation

Instructions

The following instruction are a quick reference

guide, refer to the control panel installation

manual for detailed system information.

The 5865-3 and 5865-4 are LED Annunciators

that provide you with 30 programmable LED’s

(15 red, 15 yellow). 5865 connects to the panel

via the SBUS.

Wiring the 5865-3 or 5865-4

Note: Installation and wiring of these devices must be

done in accordance with NFPA 72 and local

ordinances.

Terminate the wiring as shown in Figure 1. See

also Table 1.

Table 1: Wire Connections

5865-3 &

865-4

Terminals

FACP Terminals

Label

B B

A A

S+ +

S- -

Specifications

Table 2 lists the operating specifications for the

5865-3 and 5865-4.

Table 2: 5865-3 and 5865-4 Specifications

Specifications

Max. Line Resistance 50Ω

Max. Alarm Current 145 mA

Standby Current 35 mA

Max. Voltage 24 VDC

Operating Temperature 0° to 49° C

(32° to 120° F)

Indoor Use Only

Supervised

Power Limited

Figure 1: 5865-3 or 5864-4 Connection to the FACP

PAGE 1
Silent Knight ® By Honeywell 5865-3 and 5865-4 Installation Instructions The following instruction are a quick reference guide, refer to the control panel installation manual for detailed system information. The 5865-3 and 5865-4 are LED Annunciators that provide you with 30 programmable LED’s (15 red, 15 yellow). 5865 connects to the panel via the SBUS. Wiring the 5865-3 or 5865-4 Specifications Table 2 lists the operating specifications for the 5865-3 and 5865-4.
PAGE 2
Models 5865-3 and 5865-4 Installation Instructions Setting the Device Address 2. Place the 5865-3 into the 3-gang electrical box. See Figure 3. Refer to Figure 2 to set the DIP switches to the desired address. 3-gang Electrical Box Cover Plate Screw 5865-3 Cover Plate Figure 3: 5865-3 Mounting 3. Place cover plate over the top of the 5865-3 and align the holes. See Figure 3. 4. Insert the six cover plate screws into six screw holes on the 3-gang electrical box. 5.