Owner's manual

Model 5104B Installation Manual 151053-L8
3-18
toward you. See Figure 3-13.
Figure 3-13 Rear Mounting Plate
3. Set the desired ID for the 5230 by setting the dip switches (on = up) as follows:
*Not supervised
4. Pull wire through the wire access hole and connect the wires as follows:
5. Snap the 5230 into place by lining up the 5230 onto the restraining tabs and snapping the 5230 into place.
Note: Refer to Section 5 for 5230 Operation.
ID Number Dip Switch 1 Dip Switch 2 Dip Switch 3 Dip Switch 4
0* On On On On
1 Off On On On
2OnOffOnOn
3OffOffOnOn
130294
Quick Connect Cable
5230 Terminals 5104 Terminals
Number Description Number Description
Brown 1 Annunciator Ground 23 Ground
Red 2 Annunciator Power 24 Accessory Power
Orange 3 Annunciator Input 25 Serial Data Out
Yellow 4 Annunciator Output 26 Serial Data In
Mounting Holes
Orientation Mark
Wire Access Hole
Restraining
Tabs
Restraining
Tabs