User Guide

36
If you make a mistake while programming and you have
not yet pressed TEST , press MUTE to restore the
previous selection for the option.
If you have already pressed TEST , you must press
MUTE to exit the current menu, re-enter the correct
menu, and locate the option.
Exiting a Menu
When you finish programming options for a particular
menu, press MUTE one time.
Exit Programming Mode
To exit programming mode, press MUTE once or twice
(depending on where you are in the program) until you
no longer see the scrolling menu prompts.
Changing Menu Options
Sections 4.9 through 4.13 of this manual are step-by-
step instructions for working with each programmable
menu. In the instructions, menu prompts that appear on
the LCD are shown in boldface followed by an
explanation of the possible choices for that menu option.
The instructions assume that your system retains its
factory-programmed settings.
When a menu option appears on the LCD, it has been
selected. When an option that is available does not
appear on the LCD, it has not been selected. Pressing
the key for the option both selects and de-selects the
option.
Once you've made a change and the LCD displays the
new setting for the option, press TEST to complete the
change.
To skip over a menu option without changing it, just
press TEST .
If you want to restore the factory programming for any
menu option, (except user codes), press CHM or INT
while you are working with that option.