User Guide

27
• If you are using the duress alarm feature, make
certain that no access codes begin with the digit(s)
you selected as a duress trigger.
• Write down new access code numbers and keep
them in a secure location.
Changing a code (or adding a new code)
Do not reprogram access codes unless your installer has
recommended it. If you need to reprogram access
codes, here are the steps:
1. Make sure the system is disarmed and that you are
not in the set time mode.
2. Press 7 TEST followed by your main access
code.
3. The display will show "BULK LOAD?" If you
are programming multiple cards or codes, all of
which will have the same user profile, select Yes.
To program each card or code individually, select
No for the Bulk Load option.
4. The display shows "CODE#:__". Enter the # of
the code you want to change, then press TEST .
5. The display now shows "PROFILE#__". Select
the profile (0-15) that will be used with this code,
then press TEST . (If you selected Yes for "Bulk
Load" in step 3, this step will be skipped for the rest
of the codes you program. All codes programmed
during this session will have the same user profile.)
6. The code number for that user displays. Press
CLR , enter the new access code, then press TEST
.
7. To locate another code to work with:
press INT plus the number of the code you want
to change (not the code itself), then press TEST .
- OR -
Press TEST as many times as necessary until the
code you want to change displays.