User Guide
20
Trouble Message
If the touchpad displays "TROUBLE" while you are
arming the system, stop immediately and contact your
security company for servicing. DO NOT attempt to
arm the system until the trouble condition has been
cleared. Your system will not be fully operational
during a trouble condition.
Residential System
If you are using the 4734 in your home, you may want to
follow the procedure below when arming your system.
Arm your system when your home is unoccupied or
when residents are sleeping.
1. Make sure the green READY light is on and that the
ARMED light is off. (If the READY light is off, see
"Not ready zones" section above.)
2. If you are leaving your home unoccupied, press INT
to turn on the INTERIOR light. All zones will now be
active and you will have an exit/entry delay period.
If you are staying home, you should turn off the
INTERIOR light (press INT ). This allows you to
move freely about the interior of your home while the
system continues to detect an intrusion. For special
circumstances, you could use combinations of
INTERIOR and NO DELAY. For example, if you
wanted maximum protection from intruders while your
family is sleeping, you could arm the system from your
bedside, turning on both the INTERIOR and NO
DELAY features.
3. Enter your access code, (for example, "5432"), at a
touchpad. The green READY light will turn off and the
ARMED light will turn on. The system is now armed.
DisarmingSingle-area System
See section 3.8 for multi-area system operation.
When you open a door while the system is armed, you
will hear an entry warning tone and you will have a
programmed amount of time to enter the building and