Specifications

Model 9800 Central Station Receiver Installation/Operation Manual
4-6 151018
4.4.3 Default User Codes
At initial power up, the system provides two default user codes. User code 1 defaults with an
Installer profile and user code 2 defaults with an Operator profile. Table 4-5 shows the default
codes and their profiles.
* User code 1 can be changed but not deleted. User code 1’s profile will always remain as “installer”.
4.4.4 How to log on the system.
Follows these steps to properly log on to the system:
1. Press the button.
The LCD will display Enter Log In Code:
[ ]
2. Enter your PIN code. (See Table 4-5 for default codes.)
Note: This screen will time out after 15 seconds.
3. Press the button.
If the correct PIN is entered the LCD will display Installer # XX
User Name.
The “Operator Logged In” LED will also turn on.
If an invalid code is entered the LCD will display Access code not verified.
Note: If the previous user has not logged off, a new user can still log on by entering a PIN code. This will
automatically log off the previous user and log in the new user.
Table 4-5: Default User Codes
User Number
Default Code
(PIN)
Default Profile
1* 9800 Installer
2 1111 Operator