User Manual

SCXMIT10 418Mhz Consolidated Transmitter Installation Document
Document # 20-325-018-01 Rev IR Page 11 of 24
Silent Call Communications
3.15 SM5-MC INSTALLATION:
Please read all of the instructions thoroughly before using your Sound Monitor.
1. Remove your Sound Monitor from the packaging.
2. Place the Sound Monitor as close to the sound source as possible that you want to monitor (but not within a baby’s reach).
For example, place it on a dresser next to a baby’s bed or next to a telephone, alarm clock or apartment doorbell speaker.
3. The Sound Monitor can be mounted to any flat surface with the supplied Velcro strips or you can hang it on a wall using the
access hole on the back of the case. This step is not necessary if you will be moving the Sound Monitor from location to
location.
3.16 SM5-MC OPERATION:
1. Slide the on/off switch on the side of the Sound Monitor to the ON position.
2. Any continuous loud sound will cause the Sound Monitor to activate and the Red LED on the face of the transmitter will
come on. The transmitter then sends a wireless signal, to any Silent Call Medallion Series Receiver activating the receiver.
3. The Sound Monitor is designed so that brief sounds such as door slams, regardless of how loud they are, will not activate the
Sound Monitor.
4. The Sound Monitor leaves the factory set to 50% sensitivity, which should be adequate for almost all situations. If for some
reason the sensitivity needs to be changed, there is an adjustment dial located behind the battery door. Rotating the
adjustment dial clockwise increases the sensitivity.
5. A new feature of the Sound Monitor is the ability to set the Sound Monitor to detect a specific sound. Remove the battery
cover and at the bottom left hand corner there is a 3 position switch. Switch # 1 ON is for Sound Alert, Switch #2 ON is for
Telephone Alert and Switch # 3 ON is for Doorbell Alert.
6. Quick reference Document # 109119.
Shown set to Sound “Switch 1 ON”