User Manual

SCXMIT10 418Mhz Consolidated Transmitter Installation Document
Document # 20-325-018-01 Rev IR Page 10 of 24
Silent Call Communications
3.13 MAT4-MC INSTALLATION:
1. Place the mat where it will be stepped on anywhere except the very edge. The water resistant material used to manufacture
the TransMATTer is required to have a protective cover over it; this would usually consist of a door rug or similar covering.
2. The transmitter that is connected to the TransMATTer must not be mounted directly to a metallic surface. Doing so will
severely reduce the range of the transmitter.
3. The TransMATTer is intended for indoor use only.
3.14 MAT4-MC OPERATION:
1. Whenever the mat is stepped on, the Red LED on the face of the TransMATTer Medallion Series transmitter will
light up. The transmitter then sends a signal to any Medallion Series Receiver, activating the Receiver as a
Doorbell Alert.
2. If pressure is maintained, the transmitter will continue to transmit. Transmitter will stop transmitting when
pressure is removed from the mat.
3. Quick reference Document # 109117.
CAUTION: When handling or shipping the TransMATTer, do not bend the mat sharply or fold it. It
must be kept flat or rolled loosely or it will be damaged.