User Manual
7 Not used
NOTE: The switch settings are set prior to turning on the power. Any tampering
with the switch settings after power has been applied will not alter the address or
alarm mode of the transmitter.
The transmitter is ready to detect and send an alarm once the switch settings have been
made and power applied (ON/OFF switch turned ON).
The Sound Monitor Transmitter will send an alarm based on two conditions:
1. The test pushbutton is pressed or
2. An audible alarm is detected.
LOCATION OF THE TRANSMITTER:
Once the dip switch settings have been set and the unit is turned on:
The Sound Monitor Transmitter should be located within several inches of the audible
alarm you wish to detect (no more than 6” away). The antenna should be rotated to a
vertical position.
TESTING THE TRANSMITTER:
On units with battery, press the transmitter test pushbutton. A red light should appear
indicating that the transmitter has transmitted a signal. The length of time of the signal is
2 seconds. The receiver should indicate the alarm received by displaying the proper
ICON and LED. On Voltage Input units when applying power to the transmitter, a red
light should appear indicating that the transmitter has transmitted a signal as soon as
power is applied. The length of time of the signal is 2 seconds. The receiver should
indicate the alarm received by displaying the proper ICON and LED.
Technical Support
For technical support on this or any other Silent Call product, please feel free to contact
us. You can reach us by phone at 800-572-5227 (voice or TTY) or by Email at
support@silentcall.com
Limited Warranty
Your transmitter is warranted to be free of defects in material and workmanship for five
years from the date of initial purchase. During that time, the unit will be repaired or
replaced free of charge when shipped prepaid to Silent Call Communications. To obtain
warranty service, contact Silent Call to obtain a return material authorization. This
warranty is void if the defect is caused by customer abuse or neglect.