User Manual

Plug-in the external vibrator or telephone cables if desired.
All Fire and smoke detector transmitters should be programmed first! Please refer
to the instructions included with your Signature Series Sidekick receiver.
Turn on the transmitter.
Within a range of one or two feet from the Sidekick:
On the Sidekick press the mode button. A flashing display with the letters PPP indicates
that the Sidekick is ready to receive as well as the Yellow LED 3 will light. Press the
transmitter button, the Sidekick should show that the alarm signal has been received and
displays the alarm icon (for example the door). The Sidekick and Transmitter are now
programmed.
Place the Transmitter as close to the audible alarm as possible (no more than several
inches away). Press the transmitter button, the Sidekick should respond. If the transmitter
doesn’t respond, try locating the transmitter in another position or location.
Once a signal has been successfully received, test the transmitter again for proper
operation. The receiver should detect the transmitter again and light up the appropriate
LED and ICON on the Sidekick. The red light on the transmitter will indicate if the
signal has been sent. All alert signals received by the Signature Series Sidekick will time
out in 15 seconds provided the transmitting signal has ceased.
Sound Monitor Transmitter
The Sound Detection Transmitter operates from two standard AA Alkaline batteries with
an expected battery life of more than one year.
The dip switch settings contain:
5 settings for address. The address range is from 1 to 32. Address 0 should not
be used.
There are 3 settings for alarm detection mode. The alarm detection mode settings
are:
0 Pager
1 Sound
2 Phone
3 Door
4 CO
5 Weather
6 Fire